AIVION NA1011-ET

The AIVION NA1011-ET is the ideal solution for converting a 3G/HD-SDI signal into an HDMI signal if you have limited space, the commercial-grade is not enough and power consumption is critical.

Buy NA1011-ET
AIVION NA1011-ET

Features

One 3G-SDI/HD-SDI Input

75 Ohm MCX jacks connector. Supporting bit rates due to SMPTE292M and SMPTE424M (level A)

  • 1.485 Gbps
  • 1.485/1.001 Gbps
  • 2.97 Gbps
  • 2.97/1.001 Gbps

One SDI loop out with reclocking

75Ohm MCX jacks connector.

One HDMI output

19 pin HDMI connector. Compliant to HDMI 1.3

  • No HDCP support
  • Output Data format RGB444, 3x10 bit

Extendet Temperature Range

-25°C to +70°C (-13°F to 158°F), Humidity 20% to 70%

Small form factor

PCB dimensions 38mm x 38mm

Native video signal processing

No image scaling, no format conversion.

NA1011-ET Block Diagram

AIVION NA1011-ET

Operating Range

-25°C to +70°C (-13°F to 158°F), Humidity 20% to 70%

Vin (DC) min typ max
5V 12V 18V

Input Current Requirements

At 25°C ambient temperature

Vin 3G Operation HD Operation Condition
5V 510mA 450mA Shutdown = Vin or OPEN
12V 220mA 200mA Shutdown = Vin or OPEN
18V 160mA 145mA Shutdown = Vin or OPEN
5-18V < 10mA < 10mA Shutdown = GND

NA1011-ET PCB Connectors

AIVION NA1011-ET

J3 HDMI Output Connector

Samtec HDMR-19-02-F-SM-PF

Pin assignment due to HDMI standard

J2 (In)/ J7 (Out) 3G-SDI and HD-SDI Connectors

MCX 75Ohm

The NA1011-ET has straight MCX connectors. Right angled MCX connectors are optional available.

J1 Power Connector

JST SM03B-SRSS-TB

Pin Signal
1 Vin DC input, 5V to 18V
2 Shutdown/Reset, has pull up resistor of 4,7kOhm to Vin
3 GND (0V)

J4 Serial Control Interface

JST SM08B-SRSS-TB

Pin Signal
1 reserved, do not connect
2 reserved, do not connect
3 reserved, do not connect
4 GND
5 RX data (host to device), 3.3V TTL, 4V max.
6 TX data (host to device), 3.3V TTL, 4V max.
7 GND
8 reserved, do not connect

NA1011-ET PCB Outline

AIVION NA1011-ET

Notes NA1011-ET

  1. The Nanoconverter products are RoHS, REACH and UL/UR compliant.
  2. The device detects and measures video input parameter and adjusts all necessary settings accordingly. Manual control is not required. However, the serial control interface can be used for status checking. Any terminal software can be used, whereas parameters have to be set to 38400bps, 8 data bits, no parity and 1 stop bit (8N1). No handshake must be used
  3. The current device version does not support audio.
  4. The device version does not process HDCP encrypted HDMI input signals.
NA1011-ET| 3G/HD-SDI TO HDMI NANOCONVERTER

Price on request